Upcoming Webinars

Alarm Reason Codes and Action Codes

Wednesday, January 19, 2022 (1:00 PM – 1:30 PM ET)

Are you getting the most out of your alarm data? Join us in this webinar to learn how to use alarm reason codes and action codes to maximize the information gathered from alarm data that enters the DAS.

We will walk through all of CEMLink6’s default set of reason codes and action codes that work for various sites. We will look at customizing your own set of reason codes and action codes to meet your specific needs.

Finally, we will walk through the power of auto-coding reason codes. The auto-coding feature creates triggers that run when certain data conditions are met with newly created alarms and automatically flags data accordingly. We look forward to showing you all the Alarm Reason Code / Action Code features in this 30-minute webinar.

Audience: Prospective Customers; Existing Customers
Skill Level: Beginner

Reserve your spot today!


Introduction to CEMLink 6 webinar graphicIntroduction to CEMLink 6

Wednesday, February 16, 2022 (11:00 AM – 11:30 AM ET)

This webinar will provide basic information on VIM Technologies, Inc. and its flagship software product, CEMLink 6. Included will be an overview of capabilities, and an introduction to the software and its features and benefits.

Audience: Prospective Customers; Existing Customers
Skill Level: Beginner

Reserve your spot today!


40 CFR Part 75 Rata Test Entry

Wednesday, March 23, 2022 (11:00 AM – 11:30 AM ET)

Overview and demonstration on preparing for, performing, and entering a 40 CFR Part 75 Relative Accuracy Test Audit (RATA) in your CEMLink6 Data Acquisition System (DAS). This webinar will present and demonstrate everything relating to managing Part 75 RATAs in your CEMLink6 DAS. We’ll open the webinar with a brief description of the requirement and best practices on preparing for and performing a RATA. We will then transition to an online demonstration of the CEMLink6 compliance interface to enter and record the results. Our regulatory experts will share their thoughts and provide recommendations throughout the webinar on how to manage the test from start to finish.

Audience: Prospective Customers; Existing Customers
Skill Level: Beginner-Intermediate

Reserve your spot today!


Request a Custom Webinar

We offer the opportunity to request webinars for future consideration and for prospective customers to request a custom webinar to see our software firsthand.

  • This field is for validation purposes and should be left unchanged.

Featured News

CEMLink6 New Feature Highlights

October 11, 2021

It’s that time again!!  No, not the release of the pumpkin spice latte from Starbucks, it’s time for a recap and highlight of a handful of CEMLink6 features that have been introduced over the last year.  We’ve taken the entire list of enhancements and changes made to the product and narrowed the list down to […]

Read Post

Pennsylvania Department of Environmental Protection (PADEP)

October 4, 2021

The Environmental Quality Board (EQB) is moving forward on the Reasonably Available Control Technology (RACT) III rule that was proposed to the Pennsylvania Department of Environmental Protection (PADEP) on October 17, 2019. The purpose of this rule was to revise the State Implementation Plan (SIP) for compliance with the primary and secondary National Ambient Air […]

Read Post

Are You Ready to Comply with the New PCWP MACT Requirements?

September 8, 2021

On June 8, 2020, the U.S. Environmental Protection Agency (EPA) finalized amendments to the 2004 National Emission Standards for Hazardous Air Pollutants (NESHAP) for Plywood and Composite Wood Products (PCWP). The EPA then published the final residual risk and technology review (RTR) conducted for the PCWP on August 13, 2020.  The EPA determined that PCWP […]

Read Post